Autotether Wireless Lanyard Standard System Owner's Manual download pdf (Page 10)

o If Host is on, press and hold POWER button for less than 2

seconds to start FOB search mode

POWER Button Light (Light Emitting Diode (LED))

o Host OFF – LED OFF

o Host ON, no registered FOBs – LED steady on

o Host ON, at least one registered FOB – LED blinks

o If the battery is good (>7V) the LED is green. Flash time 4s.

o If the battery is low (>6V, <7V) the LED will be amber. 2s

o If the battery is bad (<6) the LED will flash red. 1.5s

o If the coil or the CAP is bad, the LED will be steady red.

RESET Button

o Press the RESET button to silence AUTOTETHER

alarm

o If system is not in alarm mode, RESET button has no effect.

NOTE: LED Flash times indicate cycle time. On time is always 0.5s

RESET Button LED

o Host searching for FOBs – LED Flashing AMBER. 2 sec.

o Alarm activated – LED Flashing RED. 1 sec.

o In all other situations, this LED is off.

FOB Signal/FOB Battery Level LED’s on Host

o One LED for each FOB (4 maximum)

o Host ON and

 FOB OFF or Unregistered – LED OFF

 FOB Registered & OK – LED Flash Green during Host search

mode (1 second), then OFF

 FOB Registered, batteries low – LED flashes AMBER (1

second) during Host search mode, then OFF

 FOB registered, batteries bad – LED flashes RED (1 second)

during Host search mode, then OFF

 FOB registered, signal interrupted – LED steady RED (alarm

mode)

 If the host is not in search mode or alarm mode, the LEDs

are off

FOB Controls and Indicators

POWER Button

o Press to turn FOB ON

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

No comments

Autotether Wireless Lanyard Standard System Owner's Manual Page 10