Autotether Wireless Lanyard Standard System Owner's Manual download pdf (Page 13)

a Passenger type to an Operator type and vice/versa. Contact the

factory for instructions on how to do this. .

FOB Dipswitch # 4

FOB Dipswitch #4 has four (4), two position sliders that control the

channelization of the FOB. For the AUTOTETHER

system to work

properly, each FOB and the Host must be set to the same channel.

There is an identical four (4) position Dipswitch in the Host unit

The

Host and the FOBs channels are pre-set at the factory. In the rare

occasion that two AUTOTETHER

with the same frequency are

operating in close proximity to each other, radio interference can occur

and the units will operate erratically.

This malfunction can be corrected by simply separating the two systems

so that their signals do not interfere with each other. As an alternative,

the system channel can be changed using Dipswitch #4.

WARNING!!

Each FOB and the Host must be set to the same channel for the

AUTOTETHER

system to operate.

Using an A#1 Phillips screwdriver, remove the back covers of each

FOB and the Host

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 24 25

No comments

Autotether Wireless Lanyard Standard System Owner's Manual Page 13